1.Can we take the BME688 sensor to sleep mode when the scanning is taking place? Lets say for example we have 3 scanning cycles and 12 sleeping cycles and we received the data in 1st cycle can we put the sensor to sleep from that point??
2. Another things I observed that when I am using the 1 scanning cycle and 4 sleeping cycles with the scan period of 10.8s there after the scanning phase is over the overall current consumption was around 20-30mA in case of scanning and 10mA while sleeping whereas in 3:12 cycle it is consuming 20-30mA in scanning and 0-1mA while sleeping. So what is the reason for this behaviour?
I am using the coffee Beans configuration exported from the BME AI studio. Lets say that I am using the coffee Beans configuration then how can I use these configuration along with coffeeBeans? As far as I understand it is like Hand field Sanitizer code example. So how can I add those selectivity configuration with the hand sanitizer configuration. Can I get some example code where I can take the refernce.