01-30-2022 10:30 AM
Which terminals will be used for Spi4 wired connection? The picture of the sensor I am using is as follows. No terminal named (SA0) is defined in the datasheet file, but there is such a pin connection on the sensor. There is no such tip in the diagram given on page 103 of the datasheet file. Is this pin shown as SD0?
Solved! Go to Solution.
01-31-2022 08:16 PM
Hi,
Thanks for your inquiry.
Yes, you are right. The SA0 pin on the breakout board is to select I2C slave address for BMI160. It is the same pin as BMI160 SDO pin-1 which can be used as MISO in SPI interface.
Thanks.
01-31-2022 09:40 PM
Thank you for your answer, but I missed it while looking at the BMI160 datasee. Page 89 is given in the table as you explained. I should have been a little more careful.