BMI270 INT1 & INT2 no interrupt on hardware pin

[sos]

I'm using the BMI270 shuttle board. The sensor is set up correctly and I can read data from the accelerometer and gyroscope. I have tested all the code provided on GitHub. All codes are working fine. I received all interrupts on the terminal. But there is no interrupt sense on INT1 & INT2 pin. I have map interrupt provided in the source code. I have copied the source code as it is.

Please guide me to resolve the issue.

Thanks in adavanced.

Regards,

Suhas

[BSTRobin]

Hello sos,

There was BMI270 reference code on STM32 for your reference that demonstrated FIFO watermark interrupt was output from INT2, wrist wear wakeup interrupt was output from INT1.