BMP390 DRDY state not present on External Int Pin

[andyquant]

I need to configure the BMP390 to generate an interrupt when the DRDY condition is met.

I have tired various configuration of settings.int_settings and cannot ever see the interrupt pin changing state on an oscilloscope.  It does change state when I manually toggle the pin between  Vdd and Gnd.

I have attached my code for reference.  Which appears to run and I see valid Pressure and Temperature reading echo on my serial output.

Please can someone help with this issue?.

[BSTRobin]

Hi andyquant,

You can refer to attached BMP390 example code which run well on STM32.