05-03-2024 06:49 PM
Hi,
I have a weird issue with the USB port of Arduino Nicla Sense ME. I cannot read the com port nor can I upload programs to it. However, the sensor itself and ports are working correctly. I confirmed this by USB to the Serial Converter and also by connecting the Portenta H7 to it.
My current question is, how can I upload a program by using an external programmer device? Because I can see other programmer device options in Arduino IDE. Can anyone tell me which programmer device to connect to and how to use it? I could not find any info about it on the internet.
Thanks before.
05-06-2024 01:55 PM
Don't buy the Nicla series device if you can. Or at least, don't rely on it. Before, I needed a previous version of Bosch AI Studio software, which caused me to waste 1.5 months asking anyone to send it to me and no one helped me in this forum. Now, 2 weeks left to my master's thesis, the USB port has become unresponsive (of this 90 EUR device) and I can't even find an answer on the whole internet to a simple question like how I can connect an external programmer to it. Because of this, I cannot finish my master's thesis on time and cannot publish a paper on a journal.
This device is very powerful from a hardware functionality side, but the software and community support is very weak.
05-14-2024 03:57 AM
Hi Eldar,
Thanks for your inquiry.
Nicla Sense ME board integrates nRF52832, do you want to program nRF52832 with ARM CMSIS-DAP?
Wednesday
Hi,
Yes, please. I am sure the MCU itself working correctly, but something is wrong with the USB port or the integrated debugger. I want to check it with an external programmer.