07-15-2021 10:37 PM
Hello,
After attempting to use the Arduino IDE to communicate with the ESP32 present in the BME688 development kit, I am trying to use the development kit as initially suggested by bosch. I want to plug in the board, record readings to the sd card, and upload them to the AI studio.
However, data is no longer recording on the SD card when I power up the development kit. Is there a way to reset the development kit? I have already tried adding a new bmeconfig file to the sd card with no success.
Thanks.
11-25-2021 07:11 AM
Hello AMELIE,
As you had opening COM poart error, you could check whether your USB driver was installed successfully on you PC side.
02-13-2023 09:22 PM
Hello,
What is application note?
Thanks,
Jimmy
03-08-2023 09:49 AM
You could see detailed information from https://www.bosch-sensortec.com/media/boschsensortec/downloads/application_notes_1/bst-bme688-an001....