Bme680 gas resistance value does not change i always get the result of 806516. I am working with nrf5dk and i dont know what am i doing wrong but temp,hum,press are all correct but when i read ( data.gas_resistance) the value is stuck to 806516 . this is my code to read data can someone please help me ? Best regards Efe uint8_t data[1]={140}; uint8_t reg[1]={0x74}; uint8_t rega[1]={0x72}; uint8_t regs[1]={0x73}; //uint8_t regg[1]={0x75}; bme680_set_regs(reg, data, 1, &gas_sensor); bme680_set_regs(rega, data, 1, &gas_sensor); bme680_set_regs(regs, data, 1, &gas_sensor); //bme680_set_regs(regg, data, 1, &gas_sensor); nrf_delay_ms(500); while (1) { uint16_t meas_period; bme680_get_profile_dur(&meas_period, &gas_sensor); struct bme680_field_data data; temp= data.temperature ; NRF_LOG_INFO("TEMP value = %d ", temp); pres= data.pressure ; NRF_LOG_INFO("PRES value = %d ", pres); hum= data.humidity ; NRF_LOG_INFO("HUM value = %d ", hum); air= data.gas_resistance ; NRF_LOG_INFO("AIR value = %d ", air); temp_value= temp/100; pres_value= pres; hum_value= hum/1000; air_value= air/10000; ble_cus_temp_level_update(&m_cus,temp_value); ble_cus_pres_level_update(&m_cus,pres_value); ble_cus_hum_level_update(&m_cus,hum_value); ble_cus_air_level_update(&m_cus,air_value); ble_cus_fall_level_update(&m_cus,Falll); if(data.status & BME680_GASM_VALID_MSK) printf(", G: %d ohms", data.gas_resistance); if (gas_sensor.power_mode == BME680_FORCED_MODE) { rslt = bme680_set_sensor_mode(&gas_sensor); }
... View more
