Bosch Shared
- Top Results
See all results
- About JRSAINDO
- About JRSAINDO
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About JRSAINDO
since
04-14-2022
04-15-2022
JRSAINDO
New Poster
2
Posts
0
Likes
0
Solutions
04-15-2022
02:48 PM
Hello, thanks for taking the time to assist! 1. I purchased 2 sets from Digikey. The App 3.0 boards and BMA400 shuttles. 2. Pictures of one set of boards are provided. 3. Yes, I used the datalogger binary. I even tried to update the bootloader from ...COINES\v2.6.0\firmware\app3.0\bootloader_update\. Whenever I flash datalogger.bin to it, the red LED stays solid and no BLE advertisements show up. The only time I get a BLE advertisement is in bootloader mode. So I know the BLE radio works. Both App 3.0 boards I have do the same thing. I can also flash Dev. Desktop firmware to it and it works with that app on the PC.
... View more
04-14-2022
06:25 PM
Hello, I want to test the BMA400 sensor using the BST Datalogger app that comes with COINES 2.6. I loaded the datalogger firmware to my App 3.0 board and installed the BST Datalogger APK to my droid phone. When I get to Add Device, it just scans and none show up. If I load the new bootloader onto the app 3.0 board, I do see the app 3.0 board show up in the bluetooth scan, but I cannot get a device to show up when scanning with the Datalogger firmware loaded. The app board also just shows a solid red LED. The App note says it should be flashing to indicate it is waiting to be paired. Is there a compatibility issue with the datalogger firmware and the app board 3.0?
... View more
Latest Tags
No tags yet
Still looking for something?
- Top Results
See all results