Bosch Shared
- Top Results
See all results
- About Brucelgn
- About Brucelgn
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About Brucelgn
since
03-07-2023
03-09-2023
Brucelgn
New Poster
3
Posts
0
Likes
0
Solutions
03-09-2023
02:48 AM
Hi, Thanks for your advice. The vertical axis units are as you point out. Maybe the temperature chamber vibrations cause gyro data jumps. But it is strange that gyro X/Y data will go back to the proper trend after a short time. The current internal ODR is 1000Hz with 116Hz BW. We will try to set gyro to 100Hz ODR with 12Hz BW and repeat the previous process.
... View more
03-08-2023
02:54 AM
Hi, Thanks for your reply. The smoothing method we are using is examined and works well. The raw data looks normal just because the noise is too high. The sudden jumps will disappear when the temperature continues going down. In the above case, the smoothing data shows large to 4mg change in accelerometers and 0.1°/s change in gyroscopes.
... View more
03-07-2023
12:16 PM
We are using BMI088 by SPI to get the accelerometer and gyroscope data. The ODR is 500Hz. When the temperature goes down from above 65℃, all the sensor data smoothing by 1 sencond seems to be discontinuous at some moment. The figure below shows the case. The raw data is normal. Can anyone explain what happens?
... View more
Latest Tags
No tags yet
Still looking for something?
- Top Results
See all results