Hello everyone, I'm are using a BME688 development kit in a project to read ambiental data with an ESP32. During the calibration phase, observing the data on the . bmerawdata was all correct. When I enter the firmware for real-time classification (basic_config_state), the serial is printed with completely incorrect temperature and humidity data. The firmware used are the two examples in the Bosch-BSEC2-Library-master library, specifically "bme68x_demo_sample.ino" for calibration and "basic_config_state.ino", as already mentioned. In the latter the average printed temperature value is 40 ºC while the RH is 22.33%. By measuring both temperature and humidity with the single bme680 the values I get are for quenching 28 ºC and for humidity 48%. It seems as if the values are reversed but with an error. Any idea why this is? Any suggestions on the tests I can do? Thank you very much.
... View more