Hello. I am asking advice on the following matter... I am running an 8 channel BME688 DEV-KIT (ESP32) using the Arduino environment, using the x8_board_examples. To my understanding the heater profiles are defined in a configuration like the on in "FieldAir_HandSanitizer.h" . Is this assumption correct? What is the format of the config array: const uint8_t FieldAir_HandSanitizer_config[1974] = {0,0,4,2,189,1,0,0,0,0,0,0,158,7,0,0,176,0,1,0,0,168,1 .... I'm sure it is documented somewhere but I didn't find it. The configuration I need is such as that each of the 8 sensors should heat to a single different temperature for a given time before the measurement is carried out. Any advice is highly appreciated! Thank you and kind regards Peter
... View more