About Ridah

Ridah · ‎06-21-2019

Hi JohnRob, I have already checked with example i2c scanner program given in Arduino IDE, also cross checked with a scanner program I found online by Nick Gammon and that is how I knew the adress of my i2c device is 0x47. Thank you.

Ridah · ‎06-20-2019

Thanks for replying, You are right, I'm trying in indoor as it will be used on a robot running indoors. Even tough I do dedicated calibration at a fixed point I do not get absolute value while facing towards the North, so can I please know what is calibration ? Why exactly do we calibrate? Thank you.

Ridah · ‎06-20-2019

Hi, I am connecting bno055 shuttle board ( with application board) with Arduino via i2c but running the program (read_all_data or raw_data) which is provided by Arduino gives problem detecting message ("Ooops, no BNO055 detected ... Check your wiring or I2C ADDR!"). Also when i run i2c scanner program I see an address of (0x47) 71 which should be 0x28 or 0x29 if I'm right. How can i solve this? Thank you.

Ridah · ‎06-14-2019

Hi, I used both bno055 usb stick and bno055 shuttle board (in NDOF mode) to measure the heading (in Eulers )in various points about 3 meters apart. I see lots of difference (upto 10 degrees) between the heading values. Calibrating the sensor again in that same point also gives the same value.

Ridah · ‎06-08-2019

Hi, I am trying to connect bno055 shuttle board (with its application board) with my Raspberry pi 3 Model B via i2c which is giving me clock stretching problem. Is there any way we can solve this? If yes then How?

Bosch Shared

About Ridah

Re: bno055 not detected via i2c

Re: BNO055

bno055 not detected via i2c

Re: BNO055

Re: BNO055 / Minimum I2C communication interval ?

About Ridah

Re: bno055 not detected via i2c

Re: BNO055

bno055 not detected via i2c

Re: BNO055

Re: BNO055 / Minimum I2C communication interval ?

Still looking for something?