Hi all, we are using a BNO055 with a strong magnet close to it and it works just fine, at least for our purpose. Unfortunately, some of these devices are failing after some time: in particular, the BNO055 seems to be in a failure status (not reachable through I2C commands) and it is constantly consuming around 20 mA. Unsoldering the sensor from the PCB makes the system operate normally, therefore the problem must be in the BNO. Could the magnet be the cause of all this? Just in case, here's a diagram of how we use the sensor, please have a look and tell if you notice something strange(wrong). Thanks and best regards.
... View more