About aswang

Hello, Is there a recommended way to model the behavior of the BMI088 digital low-pass filters, as described in section 4.4 of its datasheet? Thank you! ... View more

Hello, I am able to read data using INT1 from the accelerometer at 800Hz with 100kHz I2C clock frequency. However, when I increase my I2C to 400kHz, INT1 only fires at 100Hz. The gyroscope is not affected (1kHz for both I2C speeds). Do you have any ideas? This is with the Adafruit Metro M4 and Arduino IDE. Thank you very much! ... View more

Is the sensing axes origin at the center of the top face of the sensor housing (Figure 11), with tolerance +/- 0.05 mm? Also, where might I find the error tolerance for the sensor axes orientation? Thank you! ... View more