About elcaron

Well, it is constant, it is polled every 2min (withconfig/generic_33v_3s_4d/bsec_iaq.txt setting). But I guess that should read "Every 3s interval has to be read"? It was mentioned that T/H/P could be configured LP, and the gas sensor ULP. How would I do that? I woulld like to have my ESP32 sleeping as much as possible, since it causes a very noticable temperature offset, but on the other hand have temperature updates at least every 2 minutes. ... View more

How would this (different times) be set? Also, I am unclear if these intervals mean that I CAN read a new value every 3s, or that I MUST read a new value every 3s. I would be fine with higher consumption of the BME680, as long as the temperature increase is compensated, but I would like to let my ESP32 sleep for 2mins, since it increases the measured temperature of the sensor on the same board by more than a degree if left running. ... View more