Yet another question, let's call it 3): 3) Is the no-motion interrupt not retriggered after INT_STA readout or writing to RST_INT when the no-motion interrupt condition is still met? E.g. when the sensor is at rest without any movement, then no-motion interrupt is triggered. Then interrupt is reset/cleared by the host controller. Then the interrupt pin stays low (although no-motion condition is met). Is this the intended behaviour? 4) General question to other interrupts. For the accel any-motion interrupt it says in chapter 3.8.2.3 p.45 in the datasheet: "As soon as the slopes of all enabled axes fall or stay below this threshold for [AM_DUR +1] consecutive times the interrupt is cleared unless interrupt signal is latched." As you already mentioned above and in the data sheet, the interrupts are latched to the INT pint. Can you explain how to achieve clearance of the interrupt status/pin as soon as interrupt condition is no longer met when the interrupt signal is always latched to the INT pin? Can this latch mechanism be disabled? I am a bit confused about the notation in the data sheet, because it says interrupt is cleared but if it is latched then it is not cleared - the interrupt is always latched, hence the interrupt will never be cleared when interrupt condition is no longer met. Hopefully, this was not too confusing.
... View more