Bosch Shared
- Top Results
See all results
- About RknCdacT
- About RknCdacT
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About RknCdacT
since
09-10-2020
12-03-2020
RknCdacT
Member
4
Posts
0
Likes
0
Solutions
12-02-2020
09:49 AM
Hi FAE_CA1, Please support us in solving the issue with the BMF055 IC. Also, is it possible to share the BMF055 shuttle board layout with us? It would help us to compare with our custom PCB and resolve any errors that might have been created while designing our PCB. Thanks & regards, Rajeev
... View more
11-10-2020
04:24 PM
@FAE_CA1, Thank you for your reply. @Vincent Will share by private message. @kgoveas, We are not using the crystal. Its the same way as in the default code available for download in Data stream example. Also, the BMF055 is working without issues in the shuttle board.
... View more
11-07-2020
06:21 AM
Hello, Thank you for your reply. Yes, we have checked all the PCBs with BMF055 IC; we faced the same issue in them all. We even replaced the IC in the shuttle board into our PCB and still there were no changes found. The The soldering quality was checked and found to be of good quality. Our organization is named C-DAC Thiruvananthapuram (www.cdac.in), located in Vellayambalam, Thiruvananthapuram, Kerala, India. We hope that you could lop us with your local FAE for further support, which woud be highly appreciated. Also, is it possible to share the BMF055 shuttle board layout with us? It would help us to compare with our custom PCB and resolve any errors that might have been created while doing our PCB. Thanks & regards, Rajeev
... View more
- Tags:
- atmel studio
- BMF055
11-04-2020
08:08 AM
Hello everyone, We had purchased the BMF055 shuttle board along with breakout board and tested it out. Once satisfied, we had tried to implement the same into our customized board which replicated the circuit details as mentioned in the BMF055 shuttle board. But, after programming the BMF055 IC and starting the debugging process, the program gets stuck in the "gclk.c" file at while loop (Highlighted line in attachment). We have rechecked the schematic connections of our board with the BMF055 Shuttle board and there are no changes to be found. We are using Atmel Studio IDE and Atmel ICE debugger for our debugging of the BMF055 IC. The example program used by us is "BMF055_DATA_STREAM-atsamd20j18". Please support us in resolving this issue. Thanks & regards, Rajeev K Nair
... View more
Still looking for something?
- Top Results
See all results