BB350 shuttle board spi

[Enifed]

The BMM350 shuttle board 3.0 documentation states that you can use SPI… Is that an error?

[BSTRobin]

Hi Enifed,

Thanks for your inquiry.
Do you mean the following description? If yes, you can see that all Shuttle 3.0 boards of Bosch Sensortec use the same pin number of P1 and P2 connectors, and some sensors are reused in the pin allocation of the connectors. For example, the BMM150 supports SPI, and both SPI and I2C are described in the pin description. For BMM350, you can ignore the SPI section on the pin description because BMM350 does not support SPI interfaces.

[Enifed]

As the pin description is from a document specific to the BMM350 (rather than a generic shuttle board document) I relied on it when purchasing the device. It is certainly misleading. Ignoring it does not help me after the fact.  Is there a way I can get a  BMM150 as a replacement?  The BMM350 is of no use to me.