[BHI260AP] The sensor's power mode/sample rate does not change.

[monbot]

I am using the BHI260AP by mounting it on my own board.

The BHI260AP works well for a long time, but it cannot receive sensor data from a certain point.

Checking the log, there seems to be no response after enabling the sensor.
(Refer to the picture below)

In normal situation, the message "power mode/sample rate changed for sensor id #" is displayed, but in abnormal situation, the message is not displayed.

I would like to know what could be the cause of this problem.

[BSTRobin]

Hi monbot,

Could we know about your software you used?