02-26-2024 12:08 PM
안녕하세요.
가이드라인 보고서 초안 작성 완료
인터럽트 연결이 확인되었습니다. 그러나
X/Y/Z 축 벡터 값이 변경되어도 인터럽트가 발생하지 않습니다.
저는 리눅스를 사용합니다.
현재 설정은 다음과 같습니다.
레지스터는 0x53 및 0x0A로 설정됩니다. (액티브 하이 / OD=0 / 푸시 풀)
6144byte 구성 코드가 적용되었습니다.
구성 파일이 적용되었습니다.
지센서 -> MCU -> AP (MCU 및 AP는 GPIO 사용)
다음과 같이 INT_MAP에 적용했습니다.
INT_MAP_1(0x56) = 0xff
INT_TO_CTRL(0x53) = 0x0c
충격을 받았을 때 인트핀에 인터럽트가 발생하도록 설정하려면 어떻게 해야 합니까?
혹시 제가 놓친 부분이 있다면 알려주시면 감사하겠습니다.
한번 해볼 수 있도록 설정 방법을 단계별로 알려주세요.
감사해요.
03-04-2024 04:35 AM
Hi kyusanglee,
There are different BMA456 software versions(sensor API & example) which support different features for different applications on github https://github.com/boschsensortec/BMA456_SensorAPI
We suggest that you directly use the sensor API and examples of BMA456.
Could you describe your feedback in English?
04-03-2024 09:20 AM
hello.
Draft guideline report completed
Interrupt connection confirmed. however
No interrupt occurs when the X/Y/Z axis vector values change.
I use Linux.
My current settings are:
The registers are set to 0x53 and 0x0A. (Active High / OD=0 / Push Pull)
6144byte configuration code applied.
Configuration file has been applied.
Sensor -> MCU -> AP (MCU and AP use GPIO)
I applied it to INT_MAP like this:
INT_MAP_1(0x56) = 0xff
INT_TO_CTRL(0x53) = 0x0c
How do I configure an interrupt to occur on an intpin when shocked?
If there is anything I missed, please let me know.
Please tell me step by step how to set it up so I can give it a try.
thank you.