06-15-2023 03:16 AM - edited 06-15-2023 03:22 AM
Hi,
if INT_STATUS0 register is unchecked,
Will interrupt pin stay continuously low level in pull-up setting?
(Register (0x53) INT1_IO_CTRL : edge_ctrl = egde_tr, lvl = active_low, od = push-pull, output_en = output enabled, input_en = input disabled)
In sleep mode, I testing wake up by receiving interrupt signal through the single tap
After single tap, interrupt pin not return high level.
if this is not normal, How should i set it up?
Thank you.
Solved! Go to Solution.
06-16-2023 04:19 AM
Hi dhyoon,
You should read INT_STATUS0 register when interrupt signal was triggered as you map single tap.
Please refer the description in BMA456 data sheet:
06-19-2023 05:47 AM
Thank you.