07-23-2021 10:29 AM - edited 07-23-2021 10:32 AM
I am evaluating BMI088 for navigation applications.
I need to verify the gyro nonlinearity error within a relatively small angular range (-10dps to +10dps).
The test was done in the following steps.
3.1 The gyro output was first calibrated using best fitting straight line to correct scale factor and bias error.
3. 2 The calibrated gyro output at each step was compared with the set value to calculate the error which is considered as nonlinearity.
We can clearly see that when the rate table rate crosses 0dps, there is a jump in the gyro output. We tested a few units and all the units show similar behavior.
It seems there is some ADC error. Could any one help to explain and provide some kind of configuration to fix this? Thank you.
Solved! Go to Solution.
08-09-2021 03:36 AM
Could you give the feedback in previous message?
08-11-2021 04:16 AM - edited 08-11-2021 04:17 AM
sorry for the late reply.
I only tested the Z gyro because in our application, such jumps in the X and Y axis should not be a problem.
I can explain a bit about our application. It is a navigation application with IMU and RTK GPS.
When GPS is available, this kind of jump is no problem. However, the estimation accuracy of the gyro bias is lower because of the jump.
When GPS is lost, the IMU is combined with an odometer to estimate position. That is, the gyro is integrated for heading angle, and the heading angle is combined with the velocity from the odometer to calculate position. In this case, the Z gyro bias estimation accuracy and the stability of the Z gyro bias are critical.
09-22-2021 09:09 AM
We contacted you via mail with detailed communication.