12-04-2023 11:12 AM
I have a BNO055 sensor to use in a project. the sensor works very well in sensor fusion mode, but I can't store the calibration data to not have to calibrate it when starting the Arduino. Can you explain how they can be permanently stored on the EEPROM? This isn't explained well in the datasheet either. I would need a code that permanently saves the calibration data.
12-07-2023 03:19 PM
Hi Aarseth,
You can refer to the description in BNO055 data sheet.
BNO055 is not recommended for use in new designs. If you use 9doF in your application, you can use BHI360 + BMM350 in you design.