03-04-2024 04:19 PM
I want to purchase several BMM350 sensors and connect them to the same I2C bus.
Is feasible to change the I2C address of the sensor or not? Thank you
03-05-2024 07:31 AM
Hi Kassem,
As described in data sheet, by setting the B2(ADSEL) pin to high or low, you can use two BMM350 I2C addresses.
03-06-2024 11:18 AM
Thank you for responding. I have an additional question regarding sensitivity. While I can find information about the sensor resolution (0.1µT), the sensitivity is not specified. Could you kindly furnish details on the sensor sensitivity?
03-07-2024 02:45 AM
Hi Kassem,
You can refer to "Table 3: Magnetometer output signal" in BMM350 data sheet.