06-05-2023 07:43 PM - edited 06-06-2023 10:23 AM
Hi guys,
I am designed my own PCB with BMI270(only bmi270 on the PCB), which communicates with the ESP32 using I2C.This card is worked but I am encountering difficulties in establishing communication with the application board 3.0.I want to connect to the app board application using the pins (3.3v, gnd, sda, scl) of the PCB I designed, but I cannot connect to the application even though the connection is correct. Do I need the eeprom on the BMI270 Shuttle Board 3.0?
Can you assist?
06-06-2023 03:31 PM
Hi volkanmert,
If you would like to connect your own BMI270 boart to application board 3.0, you need EEPROM which was burned a shuttle ID in it.