Flash Firmware Application Board 3.0 Hang Up

[Heiko2505]

Guten Morgen,

ich bin dabei das Bosch Sensortec Application Board 3.0 zum Laufen zu bringen. Wir hatten zuerst Probleme bei der USB Driver Installation, das scheint jetzt geklappt zu haben, nun gelingt das Flashen nicht.(Das Board ist vermutlich abgestürzt)

-Wie lange sollte das Flashen in etwa dauern?

-Entspricht jener mit „T2“ beschriftete Taster dem „SW2“?

-muss ich beim Communication Interface etwas eintragen (darüber habe ich nichts in der Anleitung gefunden)

Vielen Dank!

[BSTRobin]

Hi Heiko2505,

Could we know which firmware you are flashing?
There was user mannual under "C:\COINES\v2.7.0\doc" folder for your reference.
The screen print of PCB board is marked with T2.

[Heiko2505]

Hello, thank you for your support

unfortunately it is still not working.

i found version COINES v2.7.0 i hope it is also ok.

AFter Batchfileexecution the message "cant detach" appears

Do you have any idea what i could try?

[BSTRobin]

Hi Heiko2505,

Have you successfully upgraded the DD firmware before you connect your board to DD2.0 software?

[Heiko2505]

Hi BSTRobin,

i have no luck. The IT department gave me a PC without USB lock , but it still doesnt work.

I have theUI version 3.25.0.0 running, and i took bootloader and dd fw update firmware v1.9 from coines v2.70 from app3.0 

Whenever i activate the pc Program, "initialzation failed" message appears.

In Windows device manager BST Application Board the driver 2.60.0.0 has been installed

Do you have any Idea what i can try?

Thank you and best Regards

Heiko