There was a problem running BSEC on the board

[marcusPStudent]

When using the BME AI Studio Mobile App to run a live test after collecting data, I got the following error:  There was a problem running BSEC on the board (3).

Note: I have three boards and all seem to produce the same error!

[marcusPStudent]

Anyone?

[BSTRobin · Accepted solution]

Hi marcusStudent,

Thank for your inquiry.
Ensure that the version of BME688 dev kit and BME AI-Studio Mobile App you are using matches correctly.
For example, you can upgrade to the latest BME688 dev kit firmware v2.1.5 using BME AI-Studio Mobile App v2.4.19.
See the dependence in Release Notes_DevKitFW_v2.1.5_Website_Release_29072024.pdf under devkitfw_v2-1-5_website_release package.

Could you check it firstly and give further feedback? Thanks.

[marcusPStudent]

Hi BSTRobin,

• I used devkitfw_v2-1-5_website_release to flash the board
• I'm using BME AI Studio  v. 2.3.2
  
• BME AI Mobile v. 2.4.19

I downloaded the versions mentioned from: https://www.bosch-sensortec.com/software-tools/software/bme688-software/

As I am new to using the BME688 can I confirm this was the correct process

1. Add a coin battery to the board
2. Add sd-card to board
3. Flash the board using CMD - Flash.bat
4. Save the config file to micro-sd
5. Collect sample data 
   
6. Train algorithm 
7. Save the ai config file to micro-sd

Is there anything missing in the process chain?

Also, I can't seem to find the BME AI Studio or BSEC version you mentioned in your reply. Could you signpost me? 

[marcusPStudent]

That worked thanks....