Dear Bosch Community I'm successfuly using a BME680 with the bsec library 1.6.1480 on an ESP32 microcontroller (configuration stored on SPI Flash) based on the basic_config_state.ino example. Everything works fine, the sensor is reaching accurcy 3 as it should and the config is written routinely and read at sartup as normal. When I transported the system to a different place (several occasions), the eCO2 value was never lower than about 2000 afterwards and the eVOC values was at 10'000 even after a longer time period. It was only after erasing the configuration that the sensor was working properly again. I don't understand why I this happens and what had gone wrong or what problematic handling I have done. The only way to solve this problem is to erase the configuration and then everything works as expected and normal. What happens during transportation when the sensor is not powered on? Does anyone have an idea? This is critical when I want to ship the device with a stored configuration. Best Regards, JuergL
... View more