About Severan

Hey everyone, Currently experimenting with the BME 688 sensor, and I got to test the hand sanitizer example. Worked pretty well, great work with that one 😄 This raised a couple of questions right from the get go: 1) How to get more configurations? 2) Is it possible to share them between users? For the first one, as I understood, there's two options: one, we must use a sensor connected directly to the BME studio. All fine, until I got to this point (see picture below). I guess I need one of those x8 sensor boards to do any data collection directly from the BME studio because "other boards" are not yet available. It has been like this for some time though. Any hints as to when we can expect to be able to connect, say, an ESP8266/ESP32 to a BME688 sensor, and go from there? (I'm happy to test any beta software 🙂 ) Or two, we data log with the sensor on a  non standard board, save on a SD card, and use that to upload to the BME studio. I I got this right? If so, any detailed example of the second option, while we patiently wait for the first?? As for the second question, let's say I trained my sensor to detect when my cat goes to the loo, and I want to share this "algorithm" (configuration files?) with other BME688 owners. Is this allowed? I see the above as the same as sharing these files below. Going from there, and assuming that we can share our personally developed / created configurations, is there perhaps a share location where users of the sensor can put up their configuration files, for others to browse and test on their end? if not, would it be accepted  if we (users) set up a sharing place where other users put their training configurations for others to browse and use? Very clear example of what I'm asking: Setting up a place where we could browse for configuration files created and shared by others.  Looking forward for any insight on this. ... View more