Hello there, I'm working with the BME680 sensor with `https://github.com/boschsensortec/BSEC-Arduino-library/blob/master/examples/basic_config_state/basic_config_state.ino` The temperature value seems to close (varying between 0.5-0.8 Degree C) and the relative humidity is off by 10-12%, I'm comparing the values with the off-the-shelf available temp/humidity sensor. Hardware setup: Sensor: https://www.amazon.in/CJMCU-680-Temperature-Humidity-Ultra-Small-Development/dp/B07K1CGQTJ MCU: ESP32 Node MCU Software Setup: Platform: Arduino IDE v2.3.2 BSEC Software Library: v1.8.1492 Output: ``` BSEC library version 1.4.9.2 Erasing EEPROM Timestamp [ms], IAQ, IAQ accuracy, Static IAQ, CO2 equivalent, breath VOC equivalent, raw temp[°C], pressure [hPa], raw relative humidity [%], gas [Ohm], Stab Status, run in status, comp temp[°C], comp humidity [%], gas percentage 1054, 50.00, 0, 50.00, 600.00, 0.50, 35.14, 99147.20, 43.73, 30955.43, 1.00, 0.00, 35.14, 43.73, 0.00 4054, 50.00, 0, 50.00, 600.00, 0.50, 35.14, 99146.00, 43.35, 32052.47, 1.00, 0.00, 35.03, 43.62, 0.00 7054, 50.00, 0, 50.00, 600.00, 0.50, 35.17, 99147.02, 43.01, 33230.12, 1.00, 0.00, 35.06, 43.22, 0.00 10054, 50.00, 0, 50.00, 600.00, 0.50, 35.16, 99144.79, 42.72, 33605.90, 1.00, 0.00, 35.05, 42.94, 0.00 13054, 50.00, 0, 50.00, 600.00, 0.50, 35.16, 99147.86, 42.52, 34670.09, 1.00, 0.00, 35.05, 42.76, 0.00 16054, 50.00, 0, 50.00, 600.00, 0.50, 35.16, 99145.57, 42.46, 35020.29, 1.00, 0.00, 35.06, 42.70, 0.00 19054, 50.00, 0, 50.00, 600.00, 0.50, 35.18, 99145.80, 42.40, 35650.48, 1.00, 0.00, 35.07, 42.60, 0.00 22054, 50.00, 0, 50.00, 600.00, 0.50, 35.17, 99147.01, 42.42, 35989.71, 1.00, 0.00, 35.06, 42.65, 0.00 ```
... View more