Hi, Robin. I still face other issue after fixing the repeated start. I am getting a response 0x63 for GETBCR command. This is not an expected value. Is it a valid command to read the BCR using static address? I did tried SETDASA but unable to set the dynamic address as I cannot communicate with the sensor using dynamic address. The oscilloscope shows unexpected ACK on address which confuse me. The screenshot shows I am using 0x13. The first digit may be ignored by the sensor, I am not sure. But I did tried with other value also such as 0x12. Another question is does the I3C works with pull up resistors? I am using 100KHz - 200KHz and my setup cannot disable the pull up on the fly. Thank you very much.
... View more