Bosch Shared
- Top Results
See all results
- About LHN
- About LHN
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About LHN
since
03-27-2020
01-28-2022
LHN
New Poster
5
Posts
0
Likes
0
Solutions
01-28-2022
01:01 PM
Hi everyone, We use the BNO055 in Ndof mode, and we would like to know what is the best accuracy that we can expect for the pitch/roll. The datasheet is not really clear on that point, and we have read some topics talking of a 2° accuracy, which seems very high. Indeed, we expect an accuracy of around 0.1 or 0.2° , so if the accuracy is really 2°, what can explain such a 'bad' result ? (note that we calibrate the BNO in factory, and that we reuse the calibration after every power cycle). Thank you all !
... View more
01-18-2022
09:36 AM
Hi, We communicate with the BNO in I2C, we use it in NDOF mode (Fusion) especially to retrieve the Heading/Pitch/Roll of our device. Of course the ideal equivalent would use the same package and a compatible software, but not sure that it is possible... Thx, regards.
... View more
01-17-2022
03:45 PM
Hi everyone, It's getting more and more difficult to procure the BNO055 on 'usual' suppliers' stocks, so does anyone have an idea of an equivalent of this sensor ? Thank you all, regards.
... View more
04-02-2020
04:48 PM
Hi, OK, thank you for the app note, but it is still unclear for me. Do you have a technical support I could contact directly for the BNO055 please ? Thanks
... View more
03-27-2020
04:46 PM
Hi all, I will use the BNO055 on a board which will be put vertically in a box, and I am not sure how the axis remap should be made. Compared to the default position, where the chip is horizontal, the chip on my board will be rotated around the Y axis, so according to you what should be the values of AXIS_MAP_CONFIG and AXIS_MAP_SIGN ? Thanks a lot, LHN
... View more
Latest Tags
No tags yet
Still looking for something?
- Top Results
See all results