I don't have a BHI360 shuttle board, we have BHI360 + BMM150 in the hardware designed by ourselves, how can I brush the firmware for BHI360? If BHI360 does not brush firmware, will it not be able to achieve automatic calibration and automatic output attitude Angle?
After power on or soft reset of BHI360, firmware needs to be loaded into BHI360. MCU can use I2C/SPI to connect to BHI360, and MCU can read Sensor output through polling or hardware interrupts.
Hi, we are trying to add virtual sensors with BHI360, but failed to find BHI360 SDK. We found BHI260AP SDK available, but not BHI360. Were can I find the BHI360 SDK for firmware development?
Thank you for your message. We gladly publish all publicly available information, but unfortunately we are not able to share the requested information within the community as it requires an NDA. If you need any further information on this topic, please get in contact with one of our official distributors or sales representatives to allow us to review each project on a case-by-case basis.
