12-01-2023 09:02 PM
Hello everyone, I am new with the BME688 sensor and I'm a little lost.
I am using BME688 breakout board in Raspberry Pi Zero 2 w via connection SSH in VSCode. I did this tutorial https://www.youtube.com/watch?v=TGWKcCPKhIE&t=12s
But when I try to set sudo "python3 setup.py install" I recived this:
I don't know what could be happening, does anyone know? Is very important for me. Thank you very much.
12-04-2023 03:28 AM
Hi albeeerrrto,
The python code and tutorial were published by pi3g, you can get information and support from pi3g.