Error starting with BME688 breakout board

[albeeerrrto]

Hello everyone, I am new with the BME688 sensor and I'm a little lost.

I am using BME688 breakout board in Raspberry Pi Zero 2 w via connection SSH in VSCode. I did this tutorial https://www.youtube.com/watch?v=TGWKcCPKhIE&t=12s

But when I try to set sudo "python3 setup.py install" I recived this:

I don't know what could be happening, does anyone know? Is very important for me. Thank you very much.

[BSTRobin]

Hi albeeerrrto,

The python code and tutorial were published by pi3g, you can get information and support from pi3g.