About BSTRobin

BSTRobin · ‎05-24-2022

Hi bkris, BHI260AB haven't discontinued. You could choose BHI160B, BHI260AB, BHI260AP.

BSTRobin · ‎05-24-2022

Hi Katie2020, You could see accel's zero-g offset and gyro's zero-rate offset over life time in BMI270 data sheet. If your sensor's offset were out of range in data sheet, you could refer BMI270 HSMI document https://www.bosch-sensortec.com/media/boschsensortec/downloads/handling_soldering_mounting_instructions/bst-mis-hs001.pdf and check whether your use meets this specification?

BSTRobin · ‎05-24-2022

Hi Digisolve, We could discuss the sampe topic in https://community.bosch-sensortec.com/t5/MEMS-sensors-forum/BNO055-SIC-OFFSET-amp-RADUIS-Calibration-amp-reuse/m-p/57077/highlight/false#M11219

BSTRobin · ‎05-24-2022

Hi Digisolve, The SiC generated by the laboratory has better performance. After generated by the laboratory, it is written to the corresponding register, which is usually calibrated once. After each calibration, save offset and radius, and write offset and radius after the next power on.

giomate · ‎05-23-2022

Hi Robin, im working with cumstom PCB's based on ESP32 and STM32H7 microcontrollers. I got the BME688 working, but i have some doubts about it. 1. How can I extract VOS(Sulfurs) values from the raw data? 2. gas_meas_index colum, How is it related to gas quality, or it is just a Heater state? I want to parse these data in real time to feed another algorithm , Hence, I appreciate , if you can give me some support to achieve that.

Bosch Shared

About BSTRobin

Re: BNO055 replacement options

Re: BMI270 Static Offsets

Re: BNO055 calibration reuse register sets

Re: BNO055 SIC, OFFSET & RADUIS Calibration & reus...

Re: Bme688 H2S detection

About BSTRobin

Re: BNO055 replacement options

Re: BMI270 Static Offsets

Re: BNO055 calibration reuse register sets

Re: BNO055 SIC, OFFSET & RADUIS Calibration & reus...

Re: Bme688 H2S detection

Still looking for something?