10-11-2023 03:47 PM
Hello.
I am asking advice on the following matter...
I am running an 8 channel BME688 DEV-KIT (ESP32) using the Arduino
environment, using the x8_board_examples.
To my understanding the heater profiles are defined in a configuration
like the on in "FieldAir_HandSanitizer.h" .
Is this assumption correct? What is the format of the config array:
const uint8_t FieldAir_HandSanitizer_config[1974] =
{0,0,4,2,189,1,0,0,0,0,0,0,158,7,0,0,176,0,1,0,0,168,1 ....
I'm sure it is documented somewhere but I didn't find it.
The configuration I need is such as that each of the 8 sensors
should heat to a single different temperature for a given time before
the measurement is carried out.
Any advice is highly appreciated!
Thank you and kind regards
Peter
10-12-2023 04:16 AM
Hi PeterT,
The config file is generated by BME AI-Studio and its format is not publicly disclosed.
10-12-2023 09:03 AM
Hi BSTRobin,
thank you for the prompt reply!
Will have a look into it ...
Best
Peter
11-22-2023 10:19 AM
Welcome, PeterT.