BME688 - Arduino config array format

[PeterT]

Hello.

I am asking advice on the following matter...

I am running an 8 channel BME688 DEV-KIT (ESP32) using the Arduino
environment, using the x8_board_examples.

To my understanding the heater profiles are defined in a configuration
like the on in "FieldAir_HandSanitizer.h" .

Is this assumption correct? What is the format of the config array:

const uint8_t FieldAir_HandSanitizer_config[1974] =
{0,0,4,2,189,1,0,0,0,0,0,0,158,7,0,0,176,0,1,0,0,168,1 ....

I'm sure it is documented somewhere but I didn't find it.

The configuration I need is such as that each of the 8 sensors
should heat to a single different temperature for a given time before
the measurement is carried out.

Any advice is highly appreciated!

Thank you and kind regards
Peter

[BSTRobin]

Hi PeterT,

The config file is generated by BME AI-Studio and its format is not publicly disclosed.

[PeterT]

Hi BSTRobin,

thank you for the prompt reply!

Will have a look into it ...

Best

Peter

[BSTRobin]

Welcome, PeterT.